You can also link them to a computer and send short messages to a remote radio over Fleetsync or a pre-defined message using the buttons on the front panel to a specific station or all stations (All Call). All from using DTMF signaling from a remote station. Remote Honk Alert with confirmation tone, Remote disable/enable TX, and Radio disable/enable with confirmation tone. The radio also has scan support and this works with LTR and conventional channels. These radios do support Fleetsync Enhanced Protocol and allow for unit to unit calling and Radio (Caller) ID Support.
#Will a kenwood tk 880 work digital full#
However, if the radio is used to its full potential using a Ham Repeate r or Commercial LTR Repeater you can easily stretch 100 miles or more depending on the repeater height and configuration.
They can very easily go much further the higher up you are. Using a roof top mag mount Antenna, I've been able to talk from Vehicle to Vehicle up to 10 miles away (Simplex on flat ground non-obstructed (I was on the highway at the time)). The radio is able to be programmed down to the 440Mhz range (70cm HAM) along with GMRS and of course UHF Commercial frequencies (which was the radio's intent). I chose to flash the radio back to the latest Kenwood firmware.
#Will a kenwood tk 880 work digital software#
To make these radios work you will need to order a programming cable, however, he does have the software required to change the programming of the radio. He has been extremely helpful with these radios. So far I've ordered 2 of these radios from this seller. Kenwood TK-880-H1 w/ SJI Firmware from Hotfire!
0 kommentar(er)
